611 Router & Bearing Plate

After assembling XC I ran setup & discovered that when router is lifted on Z-Axis, the yellow housing gets caught on the top bearing/shft plate & fails to lift fully to reach limit switch. Any1 else have this issue? Any help is appreciated?

Rotate the router a bit until you find a spot that clears…most of us had the same issue.

Sanded it.

Thanks for the quick replys guys!!!

Mine still interferes at the very top. I didn’t like the idea of grinding plastic off a brand new 611 router when I first built my X-Carve.

But now that the “newness” has worn off, I’m ready to bust out the Dremel…