A phone stand, but what work/bit order?

Hey! New to this, and I’m very confused as to what bits to use. I’m trying to make a simple phone stand for the kitchen.
I’m using Fusion 360. How would you go about milling this? In what order, with what bits?

I need a flat bit to carve the bottom where the phone lays, and also to carve out for the cord, but what about the rounded edges?

What should the work order be? =)

The order doesn’t matter that much other than I’d cut the whole piece out (Contour) last.
Are you using a roundover bit or a ball mill for the roundover…do that after the big pocket.

Get comfortable with tool changes before you run the job.