Left side with one corner on each side. Also you are not planning to use all 4 holes?
I opted for this type of corner joint, they were not that expensive at all directly from 80/20 considering they came with nuts and bolts already. (don’t mind the rest in pic very much work in progress)
Thanks Martin, I’ll keep that in mind.
80/20 is my gold mine, you can find them in internal connectors category. The ones you see here are 15 series 1.5inch, Xcarve is using their 10 series I believe.
I wondered what that drill bit was for… too late!
I hear ya. I ended up pulling an all nighter because I started after the kids went to sleep and ended up going well into the next day before it was carving. At least 12 hours
Angus - did you nick the dog’s food bowl for the screws? Poor dog!
Parallel port? Geckos? Mach3? LinuxCNC?
I thought they were pipe caps.
did you get your stuff?
I’m in a holding zone until the X-controller arrives, as I don’t want to have rewire my SuperPID again, so just waiting. Then it’s off to cutting (until my new 3D printer arrives shortly then it’s back to building). At least I don’t have to deal with customs, just a 60-80 hours/week job!
OK this is killing me, I have to ask ! Where the hell do you live ?
OK I don’t feel sorry for your troubles anymore
Paradise has thorns.