But there is another folder called PostP
and there is lots of files in it
Ok
ok wait
I can´t find any file with .nc at all
I´m to tired right now
Can I come back tomorrow and try again ?
I have to get something in my stomach before I´ll
go to bed
Can anyone of you helpful forum members
explain why I got this message:
When I open the UGCS and type in the G92 X0 Y0 Z0
and press the enter
a message error says Grbl has not finished booting
Please tell me what that means
Can you get a screen shot and upload it to here. Is the baud rate correctly set?
wait, I´ll get a picture
I fixed it
I changed the baud to 115200 and
yipee it worked
You are a solid rock my friend
Finaly I can start experiment with cutting
a BIG thank´s
Kristian
'm frustrated
I wonder if I have forgotten any setting in the toolpath
when I have marked what is being milled
And starts,
the cutter goes up from the zero position to the workpiece
But does not go downto the pattern , but start working in the air above the workpiece
I’ve tried another thinner bit before I started,
And that was fine
Then the bits went down to the material and milled.
Sorry if I spelled something wrong here
after all I´m Swede
Kristian
THX Phil
That sounds logical
I’ll check it out tomorrow
Right now I have a date with my pillow
I´ll give you feedback tomorrow
Good morning Phil
It didn´t worked
I took some printscreens
Please take a look and see if there is something wrong
Kristian
no i haven´t start using probe yet
but I will try another thing today
I´ll remember that Robert
Hi Guys
I noticed, when I reseted both the Y, X and Z in my UGCS
It seems to worked.
Thank´s for all the support from you guys
I have sent you all a star to heaven.
I´ll come back if the problems come back
Kristian
Hi Guys
Now I’ve got a new problem
After x-carve have cut half of ther sign
It starts to go extremely slowly.
It’s hacking
Anyone knows why
I tried to attached a small video
but it didn´t work
Hmmm that is pretty interesting