AXE Y inversé

Begue · November 12, 2021, 5:58pm

Bonjour les Amis,
Je possède une X-CARVE depuis 2015 et elle a toujours très bien fonctionné.
Aujourd’hui, j’ai un souci avec l’Axe Y : quand je veux le faire monter, il descend et inversement !!!
Quelle est la solution afin de pouvoir travailler correctement et régler ce problème ?
Je compte sur la communauté…
Merci par avance.
Très amicalement.
Joël…

SethCNC · November 12, 2021, 6:42pm

mes excuses, je ne parle pas français (google translate)

You will need to read the grbl setting for $3 and then alter per this chart, changing only the Y axis reading.

Here is the source page in case copying the text is required for translation purposes.

github.com

gnea/grbl/blob/master/doc/markdown/settings.md

## Getting Started

First, connect to Grbl using the serial terminal of your choice.

Set the baud rate  to **115200** as 8-N-1 (8-bits, no parity, and 1-stop bit.)

Once connected
 you should get the Grbl-prompt, which looks like this:

```
Grbl 1.1d ['$' for help]
```

Type $ and press enter to have Grbl print a help message. You should not see any local echo of the $ and enter. Grbl should respond with:

```
[HLP:$$ $# $G $I $N $x=val $Nx=line $J=line $SLP $C $X $H ~ ! ? ctrl-x]
```

The ‘$’-commands are Grbl system commands used to tweak the settings, view or change Grbl's states and running modes, and start a homing cycle. The last four **non**-'$' commands are realtime control commands that can be sent at anytime, no matter what Grbl is doing. These either immediately change Grbl's running behavior or immediately print a report of the important realtime data like current position (aka DRO).

This file has been truncated. show original

system · February 10, 2022, 6:43pm

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.