Inventables Community Forum

Can we get a 'Turn Off Spindle' option for XCP?

I know there has been some discussions about how to turn off the spindle of the X Carve Pro, such as taking apart the box and adding a switch, modifying the firmware, etc…

Can we get an “official” way to turn off the spindle?

Case in point:

Long carves (overnighters), where you need to pause, then pick back up in the morning… You can ‘pause’ the job, but the spindle keeps on spinning. I personally would love a way to ‘pause’, maybe even save the progress? shut down for the night, then resume in the morning.