Cannot get my X-Carve started!

[LarryM]

You can either use the serial monitor (close down Easel) or the Machine Inspector, but get me the $$ output again now that you have run setup and post it here.

Then read through this:

[Guide] Offset cutting, Lost steps, Positioning errors, etc

Positioning Errors One of the most asked about troubleshooting problems with a new X-carve is positioning errors. Almost all positioning errors are corrected by adjusting the various parts of the machine. Very few of the problems are actually due to failing components. The X-carve is a very flexible machine and so one answer cannot fit all situations. Each person will use their machine in a different way which makes it difficult to precisely quantify each adjustment. Positioning errors are alm…