Carvey Power Switch - Need to Switch Twice to Power On

I know that these forums are a bit dead since the Carvey is no longer in production, but I figured I’d throw this problem out to see if anyone had any suggestions.

My Carvey works great, but for some reason I need to flip the power switch twice to get the Carvey to turn on. Once the power is on, the Carvey works as normal, but after being powered off it requires a switch on-off-on to get it to power up. Any suggestions? Thanks!

Do you have the internal power supply?
Clean it out with some canned air or a careful blast with a compressor.

Might be a bad switch too. Cana you check the contacts there?

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.