Carving from the centre of a piece

[HaldorLonningdal]

Work zero (or Home Position as Easel calls it) can be set to anywhere the machine can reach.
To set work zero to the middle of a piece of material, the center of the design to be carved must be centered over Easel X0Y0 grid.

See this:

Setting a different home position in easel

Easel always treat its X0Y0 grid to be Home Position (work zero) (Do NOT confuse home position with homing) Work zero can be anywhere within the reachable area of your machine, but in terms on Easel and work zero, the X0Y0 grid is where work zero need to be established. [Easel-Zero] Easel will only preview the project in its 1st quadrant, but any quadrant can be used as long as its reachable by the machine. [Easel-Zero-quad] If you want to set work zero at the center of your design, your…