Change bit on project

[CoreyMitchell]

Two stage cuts

I couldn’t find this in the UI. Using other CAM systems it would set up to first do a rough cut with a large bit, and then go back and fix the detail with a small bit. Like if you are cutting a pocket with sharp inside corners, you would want to use a really small bit to get those corners, but not to cut out the whole pocket. So is there a way to do a rough cut followed by a detailed cut, or is this on the feature roadmap?

There is a feature being developed that allows for a rough pass and a detail pass. I believe this is what you want. Reply to this thread and Inventables will give you early access to the feature. You can then select two bits for your project.