Computer connection to X-carve while using Easel

Let’s say I am using Easel. I send a job to the X-carve. Does the job get stored or flashed to any internal memory in the controller…? After the job is sent, can I disconnect my computer or does it need to be connected and online during the entire run of the job…?

Right now the computer needs to be connected to X-Carve for the entire job. Easel sends the instructions in real time rather than downloading the entire job at the beginning.

Hey Zach, are there options to run it wirelessly like though WiFi perhaps

Check this post on the RN-VX WiFly

1 Like