Confused about toolpaths

I see lots of talk about tool paths, roughing and finishing passes, etc.

Within Easel is it possible to dictate tool paths? If so I haven’t noticed where those choices are. Maybe those are choices in other programs like V Carve? How do you disquingush between a roughing pass and a finish pass within easel, or does this require other software as well?

I haven’t yet done anything that would require any of these techniques, but certainly expected to at some point.

I do not think is a choice in Easel I probably missed it. There is a choice in Vectric to select bought rough and finished cuts.

Two stage cutting it is. I’ll give it a look. Thanks very much