Drawing photo with the x carve and easel (or other software)

Hello ,

Sorry if this has been asked before but I would like to use the x-carve as a plotter.
I have downloaded and printed the sharpie pen holder but I can’t seem to get the toolpaths right (neither in easel or aspire).
Can anyone provide me with step by step instructions to have a detailed toolpath from for example a family photo?

Thanks in advance , hope the question is clear for everyone.
Kind Regards,

Hi Jurgen =) You may want to try an Engrave toolpath in Aspire and treat the pen holder like a spring loaded drag bit.

Thanks Robert , i’ll give it a go