Easel z zero Probe Feature

[LarryM]

You can use the Arduino/gShield electronics.

Take a look at the screen shots at the beginning of this thread:

Probe failure bug

I’ve set up my touch probe, but it’s not working when I try to run a carve. One thing I did notice during the probe setup is that the probe contact shows green when it’s NOT touching and red when it is, so this might be reversed somehow. What I found when I try to run a carve is that the “plug the lead into the carriage” button is grey - not sure how that’s supposed to be sensed, but the probe I’m currently using is plugged directly into the back of the X-Controller so it’s never NOT plugged i…