First attempt at some CNCing

Finally got the new XCarve up and running and had a few test carves.

Just my name in some plywood and a bird picture, should have used a smaller bit to get the details on the birds but it was a first go.

Then decided to do an inlay in some corian offcuts i had, i didnt bother with the inlay app just did fill on the black and outside line on the white and glued then together sand and polish.

Looking forward to trying a few more things in easel and then looking at trying vcarve and fusion 360.


Those are a great first go at it. This type of technology is rewarding and painful at times but just take deep breathes and try again. This community is very very helpful, so do not be afraid to ask a question if you cannot find the answer after a forum search.
Again welcome and enjoy.