SOLD: X-Carve 750mm with J-tech Laser

[Ev1]

Hi,
I’m selling my X-Carve 750mm.
It has seen very little use, and i have lots of extras with it. I have a laser kit, that i have not hooked up, so its’ all still in box. I don’t have the space for it, so it needs to go.

It is Located near Nanaimo BC, can meet on the Island.

$2000 CDN

+X-Carve 750 with Controller
+J-tech 3.8W Laser Kit (Value 700CDN)
+Desktop Windows Tower Computer to Run the System will also be included. Its an older AMD 8gb Ram Gaming computer that runs the G-code sender and software well.

Comes with:
-Controller,
-NEMA 23 motors,
-Homing Switches,
-Z-Probe,
-DeWalt 611 Spindle,
-Lots of Engraving Bits,
-J-tech Laser 3.8W with Driver Kit
-Laser Protective Glass

[RyanMeyer1]

Do you have any pictures of the setup?

Is this the original or the XC 2?

Thanks!

[Ev1]

Hi Ryan,
I got it in 2017. So i think its an original. It was the newer one at the time. The laser is all in original packaging. There are more dremel bits and extas not in the photo.

[Scott7]

hey is this still available?