Freezing at one spot

X-Carve Troubleshooting
1

Having issue with my machine. I’m sure my garage is not an ideal location, but it’s what I have. My issue is that my machine can’t seem to make it through a carve to the end, I’m sure that I have a wire crossing creating a short. I have rebuilt the whole standing table for my machine alone. I’m going to go ahead and post some pictures of my setup, I’m sure someone can spot the issue.

2

XC1
XC1480×640 123 KB
XC2
XC2480×640 115 KB
XC3
XC3480×640 116 KB

3

Freezing => usually mean that the USB-link picked up RF-noise or power management entered sleep mode.

Try a quick search here in these forums for “carve freeze” and browse through them for some pointers on where to look. Hope that helps :slight_smile: