Gshield v5 not sending signal (Zaxis issue)

Hi all, looking for some help as a new user. I accidentally crashed my Z axis while messing around and had to do a hard stop. When I powered back on I no longer can jog the Z motor. I swapped the X wire and it was able to drive it just fine so I dont think it is anything mechanical. When I power on the gshield I only see two LEDs lighting up for the X and Y axis and the one next to the Z is off. I have tried resetting everything I can but no luck. Did I fry something on my gshield? Any thoughts?

IMG_9135 Small

1 Like