Jogging feature request

Not sure if this has already been submitted. I’d like to request a jogging feature as a machine control option without going through steps to carve.

Currently the only way to step is during setup of a carve job or using advanced GRBL commands.

Would like the ability to specify units, number of steps and in any axis.

Thank you

7 Likes

I’d like this feature to please where

  • Head could be jogged in increments (eg 0.1mm, 1.0mm or 10mm)
  • Head moved using XYZ positions from machine XYZ (eg 100, 150, -24)
1 Like