Lining up Circle pieces

I have done many square and rectangle signs. I have a question.

I have a few nice pine rounds from my local home store. They are 15-18” in size circles. I want to carve a few nice signs onto them but are not sure how to put the already made circle down on the waste board, and then line up the start point etc etc.

Zero off the center of the piece. That is the easiest way with an already round piece.


How? Sorry. Haven’t done it. Always started in lower left corner.

1 Like

Under the shape tab while the circle is selected set the X and Y to 0.000 in.
Then you have to set the home position to the center of the circle.


I am so happy to see that the issue have been solved. Please keep sharing this type of info.