We use cookies to personalize content, interact with our analytics companies, advertising networks and cooperatives, and demographic companies, provide social media features, and to analyze our traffic. Our social media, advertising and analytics partners may combine it with other information that you’ve provided to them or that they’ve collected from your use of their services. Learn more.
Just to be clear, when you say “standard electronics” you are talking about the X-Controller correct?
I was looking at the Gecko website and really like what I see there. I am probably going to go with a water cooled spindle and I think the Gecko electronics will match up nicely with the VFD. Thank you for showing me the Gecko electronics.
I’ve been looking at the Gecko electronics and really like G540. I’ll probably be buying one like you did, but I was wondering why you also have the G251. Do you have two X-Carves, or somehow using both on one machine?
The Gecko G540 controls 4 stepper motors, 2 on Y-Axis, 1 on X-Axis and 1 on Z-Axis. I added the G251 to control a fifth stepper motor that runs my rotary axis.
Over the past 15 years I have had several occasions to return Gecko divers (some out of warranty that I probably damaged by my bad wiring) back to Gecko for repair, and I never was charged for any repairs, or return shipping. Gecko customer service is unequaled in the hobby cnc world.
John
I am running it on a fairly new system, windows 10, 64 bit. I do not have a parallel port so I am running the ethernet smoothstepper and connect with an RJ45 (ethernet) connection.
I think I’m going to go with a G540, Super-PID and Mach 3.
Funny thing is we had a real old computer upstairs in a spare bedroom I was about to just throw in the trash.
Today after work I walked up there to look at it.
Windows XP, Pentium 4 2 GHZ, 1 GB ram, Geforce 6800 with 256 MB ram and the MB has a parallel port.
Perfect to just run a CNC.
So now I’m cleaning all the junk out of it and then defrag the HDD.
I had my heart set on getting a Super-PID, but then I read on this forum somewhere that for slightly more I could get a water cooled spindle which would have many added advantages.
I have a CO2 laser that has to be water cooled. I have a setup with a water tank then it goes through an aquarium water chiller then through the laser tube. It works great but it’s upstairs in the house.
I looked at those spindles but I’m going to put the xcarve in the garage / wood shop and it get’s below freezing here.
The garage is insulated and I do have a natural gas heater in there but I don’t want to run it all the time just to keep my spindle from freezing.
If I lived in a warmer climate, I would go with the water cooled spindle also.
Yeah that’s the only drawback to water cooled. There are ways around it but it starts to get pricey. What about air cooled? Still better than the DeWalt spindle. Here’s a breakdown of what has to happen to install the SuperPID:
I had it assembled. So when it arrived to me it was all complete. Unfortunately, the man who did this seems to have stopped making them.
This has the G540, G251, 48v 12.5 amp power supply, ethernet smoothstepper, relay for the router, plug for limit/homing switches, plug for 3 axis zeroing plate…and so on and so on
It looks really nice. It’s probably the route i’ll go as soon as I save up. I found some real nice heat sinks coated in ceramic last night. Will look for an G540 enclosure tonight.
I went with the UCCNC software instead of Mach3/4 and the UC400ETH controller instead of the ethernet smoothstepper. I’m very satisfied with the combination and with both coming in at about $215 it’s a good deal.
You can get them from either Automation Technology or CNC4PC.