Need help with Machine settings

Yesterday I done an upgrade with a Super Z axis belt drive and stiffeners and risers. Prior to that I was having some issues with my machine settings. Taking advice from several different people with different suggestions I fear I have messed up my settings. When I try to run a carve now I always set everything up in the bottom left corner of my piece the bit always goes to the top right corner and starts my carve. Can any of you share the proper recommended machine settings? Thanks to those who help.

Please share your current GRBL parameter values and if possible an Easel file showing your design/setup.

1 Like

Did you get the pics I sent you?

No, I haven’t seen anything.

@EricKHolder Probably better to use this thread instead of PM-ing us.