@JamesMccarty Hooked. 
@MitchWillard Ouch, sorry about that. I hate it when a project is going smoothly then at the last minute something crazy happens. Have you been carving things just fine without gcode import, or does it only happen with imported gcode?
There are a few hardware issues that could cause your issue, we should rule these out first. At first glance, I’d say to check your potentiometers on both X and Y. It looks like the X direction lost steps, so turning that pot up would be the first thing I’d do. Check out this thread of an indepth guide to setting them: Setting the stepper motor current limit
(Also, please keep the hardware troubleshooting questions out of this thread, if you need more help just do a quick search or make a new topic, Thanks!)