Brand new setup, Y-Axis is not working. almost like motors are going in wrong direction, when I disconnect 1 Y-Axis it works, but slug-ish and vice-versa, when I cannot them together, Up moves right, down moves left. I dont understand! Hopefully video helps.
Most likely you have both y stepper motors wired the same. 1 needs to be wired backwards of the other. If you double check the instructions it will tell you how to wire them.
What Wayne said.
There’s a wiring schematic in the assembly and it has you swap a pair of wires on the Y2. You’ll need to go back to that and verify, just swap back if yours is wired per the manual.
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.
