I’ll check out the cut per pass next time I run a larger setup. Probably shouldn’t have cut that deep anyway.
I adjusted the x axis. It was high on the right. Think I have it really close now.
I also noticed the right side Y axis is dragging a bit. Read around, and made a bunch of the tweaks suggested in the forums. I adjusted the belt on the right side, cleaned the wheels, checked the wiring for Y2 going into the board, checked to make sure the dials on the board were set even, and checked to make sure the ribbons were seated firmly. Still getting drag on the right side. Any thoughts? Video for evidence. And the sample I was cutting to show what it’s doing to my pieces.
