No more depth first in Easel?

[GeoffEvans]

Take a look at this topic for all the major details.

Stop easel reversing direction with tabs

@Zach_Kaplan @JeffTalbot I cetianly hope this is a temporary quirk and not the final solution but my cuts are not reversing at all now! i.e. If I were cutting a line every pass it will start at the top, carve the line, then lift and go to the top of the line to begin again, EVERY SINGLE pass, even if it is not a thru cut. This is adding tons of additional z travel and thus cut time. We wanted it to stop reversing at the tab height on closed objects. At least that was my thought. This lifting ev…

Short story to try and fix the climb milling during the tabs phase they reverted to the old system. They plan to do a fix so that it does it the depth first but correct the climb milling issues.