Play music on the xcarve

Ok this will be my last post on this subject promise. I did a little better job this time still a little off key but hey this aint no guitar.

National_Anthems_-_United_States (19.7 KB)
USE AT YOUR OWN RISK I AM NOT RESPONSIBLE FOR THINGS GOING WRONG OR DAMAGES. BY DOWNLOADING YOU AGREE TO MY TERMS. but if you choose to run the file place all axis on center. I have only ran the code in picsender and the file is set to metric also i have only ran this code on 1000x1000 xcarve.

If you would like to try this for yourself
get a midi file here
get a editor here
upload midi to here to make gcode
alot of playing around you will learn some stuff


as far as i know it has to be a midi file but there are ways to convert mp3 to midi but i have yet to find any good ones but if you know any musicians that use a computer to make music they could more than likely create a midi and if i get the last bit straightened out i will repost it.

i had the same issue with some but not all

it can be done on smaller machines

1 Like

Phil you have way too much time on your hands.

1 Like