Pulling work back

hi im not sure where else to ask this.i was using the desktop router to engrave an image,ive had to do this in sections but the computer crashed,as I have gone back onto easel software the full image isn’t there,is there anyway of pulling this back,ive tried going to undo remove but it isn’t there

I think its lost.

To avoid getting into a similar situation next time, dont work off the source project. Duplicate the whole project and use that as a source for splitting it up. That way you dont touch the source project, just a "work file " off the source file.

1 Like

thankyou for your reply,i still have 3 more of the same to engrave and was hoping it wasn’t lost