Hey everyone, first time to post here but have learned so much over the past year going through the forum. I’m having issues I didn’t notice before on other two stage carves. I did just notice that my depth per pass for the roughing bit is .06”and my detail depth per pass is .05”. As you can see though, my overall depth is only .04”. It’s been a while since I’ve done 2 stage carves but I don’t remember worrying about the depth per pass if my overall depth was shallower. Would this cause the issue I’m seeing? You can see it in the corners of the letters and near the spikes on the dog collar. It’s noticeable throughout. I use the z probe function for both passes with the touch plate in the same place. Thanks for y’all’s help!
