Roughing to detail pass

in easel when doing a carve with a roughing pass and a detail pass can i use last home position when switching from say 1/8 straight cut to a 1/16th inch bit (shorter) am i going to need to reset home or does easel know the difference between bit length and im allowed to use last home?

Take a look at this video I posted today

This answers your question


I do not trust last home. I have had the machine lose the position and run wild

Use last home but you will need to probe Z again as the bit will be at a different height

Machine cannot measure length of bit with out probing.
Probe and use Last X,Y position.

1 Like

thankyou all who responded and i watched the video aswell was helpfull and congrats on your 200+ subscribers

1 Like