I’m posting this here because I know many people have been talking about lasers and I hope to put the money towards an X-Carve.
It is the 5th generation laser made in 2013. It is a 20x12 capacity but just shy by about .5" either dimension. It has been used to cut or engrave signs, coasters, and much more out of wood, acrylic, glass, paper, matboard, and cork.
Comes with everything needed to run it including exhaust blower, ducting, water pump, and air compressor.
It will need a new tube which is $300 from fslaser.com. It does have a crack in the acrylic lid with some bubbles but if desired I could get a new one made for the cost of the acrylic.
I’d also be willing to train the buyer on the software that connects to the laser. I can provide more pictures if desired.
Asking $2,500 or best offer. Located in Simpsonville, SC.
