Equipped as follows:
Acme Lead Screw for Z Axis
CNCCrive U300ETH Ethernet Motion Controller
Leadshine MX3660 3-Axis Stepper Driver
Inductive Proximity Sensors on X, Y, Z axis
Custom Electronics Cabinet with Remote Emergency Stop
Dewalt 611 Router
Precise Bits Collets (set of three) with Precise Bits Precision Collet Nut and wrench for Dewalt 611
Triquetra Auto Zero Touch Plate
Vacumn Shoe with 2 1/2 inch adapter and Festool Adapter
Inventable’s Spoil Board
HP250 G5 Notebook Computer with Windows 10 Pro installed and UCCNC Motion Control Software installed with product key.
The U300ETH is compatible with Mach 3 and Mach 4.
The original Arduino Controller is also included.
This modified X-Carve runs incredibly smooth thanks to the Leadshine MX3660.
I have used Fusion 360 which has a UNCNC post processor
This system will not work with Inventables Easel Software as currently set up.
I live in the Dallas/Fort Worth area. I would prefer to sell locally so the system would
not have to be dismantled and could be demonstrated to the buyer.
However, I will ship system if necessary.