OK. It’s still not working, but I have more info…
1st - I was editing the file in PostP and not MyPostP so it wasn’t working…
2nd - downloaded the Vectric_X_carve pp files and put them in the MyPostP directory for9.0
I had to restart VC before it would recognize it.
I start a carve and the spindle fires up, does it’s thing, returns to home and still runs. The gcode window displays:
Skipping line: M30
**** Finished sending file in 00:00:16 ****
The m5 was never sent despite it being in the .gcode file.
IF I hit the red stop button in UGS while it is carving, the spindle will power off.
If I look at the gcode file, the last lines are:
G0 X0.0000 Y0.0000
This is very odd.
Everything works fine in Easel, too.