Stop the carving for the night

Can I stop my carving and resume tomorrow?? If so HOW

What software are you using?

In Easel I think you can just hit the pause button.

I am using Easel. That’s what I just did. If it completes the job tomorrow i will post it. Thank you

Hit PAUSE, leave all electronics ON / Spindle OFF, turn spindle back ON and click RESUME when ready :slight_smile:
I usually take note of the XYZ- position in case something for whatever reason reset during the PAUSE period. (unless I have a fixed reference point)

Make sure that you do these steps in order or you’ll break a bit or damage your work.

Ask me how I know :stuck_out_tongue_closed_eyes:


Broken bits and ruined work :stuck_out_tongue_closed_eyes:



1 Like