Switches, Meters, Grbl? - This wasn't in the commercial

[NeilFerreri1]

@BrandonR_Parker

Remove the limit switch wiring and short from one Limit to the GND next to it (ie. short from XLIMIT to the GND to the right of it. If you do not get the signal in the machine inspector at this point then either something is wrong inside the X-Controller from the assembly or something is wrong with the hardware itself.

Was it not clear when I said that?

[BrandonR_Parker]

Who knows …

I posted right as you were posting, but I added a picture for reference. As long as the OP understands that the problem is likely not really resolved, I don’t think it really matters.

{:0)

Brandon Parker

[NeilFerreri1]

@BrandonR_Parker

don’t think it really matters

I meant that sincerely. I am pretty much only here to help when I can. I just want to make sure my post wasn’t confusing.
In that way, it does matter. I’m sorry if it came across differently.

@BrandonR_Parker

OP understands that the problem is likely not really resolved

Agreed.

[BrandonR_Parker]

Right, and I’m saying that I posted just after you. I did not see your post when I posted mine because the browser window had not updated. There’s a very limited number of places to check for limit switch issues, and we just happened to post about the similar things very closely together.

{:0)

Brandon Parker

[NeilFerreri1]

@BrandonR_Parker

I’m saying that I posted just after you

Yup…got it. Was never concerned about that. Just want to make sure I’m not confusing people.
Feel free to clarify my posts anytime…

[AdamSwingler]

The picture helped. I also like to read coloring books. Thank you again.

[BrandonR_Parker]

They are the best…!

{:0)

Brandon Parker