Steve,
I honestly have not looked at that. I will pay attention to it when I try again this afternoon.
I did check the V-wheels but will go over them again just in case.
In regards to the lifting the router. If there is play would that also be the v-wheels?
Thanks for all the help.
Joe
Dominik,
Thank you for the input. i will take a look at that as well.
Much appreciated,
Joe
Thank you to all who chimed in on this post. All your advise and assistance has been great.
After working 80+ hours a week for the past 2 months. I have only had the x-carve a few months and have had little to no time to figure many of the ins and outs of it.
I finally had a few hours today to work with the machine.
I readjusted all 4 of the z axis v-wheels, tightened all 3 belts and did some overall fine tuning.
The end result was just what I was hoping for. I have some adjusting to do on the text but am happy with the finished product.
The cuts were clean and the surface was smooth and flat.
Thanks again,
Joe
Big differance from the first cut.Looks good.
Looks good! Happy to help! As you have just found, this forum is awesome!
Steve,
Yes, this forum is amazing. Honestly, when I was on the fence about purchasing the x-carve this forum was one of the deciding factors in my pulling the trigger. I was a bit intimidated with the machine but saw the support and help here.
