Inventables Community Forum

Tuning all axis so they move the correct length with lead screws

I recently got an x controller and im using it with easel. All three of my axis have lead screws that all need to turn a different amount to move the correct distance. I dont mind doing some tuning in fact i suspect ill be dialing them in for a while but I dont know where in easel to find those settings and which values to change once im there.

You need to adjust a few of the GRBL settings. See my post#3 in this thread.

Calibrating my X-carve 1000 - X-Carve - Inventables Community Forum

2 Likes

thanks! so 100 is x, 101 is y, and 102 is z is that correct?

Yes, if you look at the link in that post it describes what they all do, which is good to know for some of them. You may want to change speeds and such.