Universal GCode Sender (UGS) and Large Files (64mb+, 10,000,000+ lines)

[HalfNormal]

@JohnMakowsky

From what I read PicSender is the best and I can’t use on Mac.

The fine gentleman at PicEngrave have used a cheap sub $100 windows tablet without any issues.

$78.00 10" Windows 10 tablet at Walmart

I purchased one online @ Walmart.com, added a 64gb SD micro memory card and a Bluetooth mouse. I loaded PicEngrave Pro 5, the Arduino driver and PicSender on it. I just finished a 3 hour 20 min laser photo engraving with our EmBlaser. The RCA tablet works like a charm and I did not notice it getting warm at all.

With the cost of Windows PCs and tablets at an all time low, I would suggest in investing in one and get on with
enjoying your X-Carve!