V Bit Carving Issues (ridge in middle of cut)

[CoreyMitchell]

V carve didn't clean out cut

I did my first V carve using Inkscape to create a png and then using F Engrave to create the gcode. It cut out well except it left a thin piece of material in between two passes of the v bit. I was able to chip out the excess but I definitely don’t want to have to do that again. [image][image] Here is my settings for F Engrave [image] It did not generate any clean up code so the one pass with the v bit should have been enough. My only guess is maybe my bit is smaller than .125 and did no…

Similar issue to this right?

1. Measure your bit width with calipers. Make sure the actual size matches what you are setting it as in aspire.

2. I’m not too familiar with aspire but there should be an option to decrease step over of the bit.