Nice. Will probably move me to wire up an automatic spindle for the 611. Just using a remote control right now.
Not to hijack the thread, but the picture begs me to ask. I can’t for the life of me figure out why Inventables went to the expense of supplying shielded wire and not have us ground the shields. Without a ground the shield is wasted. I also noticed that the case of my X-Controller was not fully grounded. So I ran a wire from the AC ground at the internal power supply to the X-Controller case. Then I combined all of the shield grounds and attached them to that case ground. Also used shielded wire on the limit switches. My wiring could be prettier but now the shielding should be effective.
