Wiring up controller for spindle and dust

Hi everyone new guy. I was wanting to know if there is a way to wire up the spindle and dust so that the controller can turn them on and off automaticly? Any help would be appericated.

Search the forum for IoT relay.


This works perfectly.


I use the IoT power realy and it works nice. Just don’t overload it

Look at this Facebook post. This should help you. https://www.facebook.com/groups/346976428975186/permalink/480707485602079/

Drew this up quick so a little sloppy

Thanks. Didn’t even think about that. But now you all have a reason to join it. LOL