WTB - X-Controller

Looking to buy an X-Controller for my upgraded Shapeoko. I’m setup for PayPal. Thanks!

I thought it was obvious that I was looking to save some money by purchasing a used one but I guess not. So, if you have a used X-Controller or are parting out an x-carve, I would be interested in purchasing your controller. Thanks again.

Why not build your own? It’s really not that complicated to build based an arduino uno and a few motor controllers add power supply and some shielded wire you’ll be up in no time.

Yes I have built 2 for x-carves

This topic was automatically closed 91 days after the last reply. New replies are no longer allowed.