X Carve has excessive vibration/louder than normal

[LarryM]

There is a lot to be learned and there are some good sources of information here, so dive in and after a while you’ll start picking up on it.

Read this thread and see if it helps. There are lots of interlocks that will become clearer as time goes on.

[Guide] Offset cutting, Lost steps, Positioning errors, etc

Positioning Errors One of the most asked about troubleshooting problems with a new X-carve is positioning errors. Almost all positioning errors are corrected by adjusting the various parts of the machine. Very few of the problems are actually due to failing components. The X-carve is a very flexible machine and so one answer cannot fit all situations. Each person will use their machine in a different way which makes it difficult to precisely quantify each adjustment. Positioning errors are alm…