I have a SO2 that I upgraded to the x-carve. I’m still using the arduino and gShield. The machine was running fine last night, when Easel asked me to upgrade. I clicked yes and now the machine is nearly a brick.
When it is powered on, the fan spins but I can freely move the carriage on all three axis. This leads me to believe that the stepper motors are not getting power. However, nothing I can think of that I did should have affected the electronics. The correct lights light up when i move the carriage, so my motors are still connected.
Nothing changed with my electronics. I’m at a total loss.
My first solution was that i needed to re-flash the arduino. So I followed the directions here
https://inventables.desk.com/customer/en/portal/articles/2058884-how-do-i-re-flash-grbl-to-my-x-controller-arduino-?b_id=9563
But when i open up Easel and I try to re-setup my machine, I cannot jog the axis.
Please help