X-Carve Stops Moving After Homing

[GregNiles]

When I run the machine set-up wizard the motors will not jog using the on screen buttons, but when I continue through the wizard, the motors will engage and work properly during the homing sequence. After the homing sequence the machine stops working and will not jog with on screen buttons, keyboard keys, and will not carve.

Any help or advice would be greatly appreciated.

[HaldorLonningdal]

Anyone Use CNC4Newbie Ultimate Upgrade Kit - Need Help

Open Easel-Machine Inspector (CTRL+SHIFT+D) Does it display an alarm state? When homing the sequence is as follows: Tap Z-switch once, pull off 1mm then tap again at a slower rate (= double tap) Tap X & Y once, pull off and tap 2nd time If these steps are completed you will be able to jog around/carve. If these steps are not completed an alarm state will present.

[GregNiles]

Thank you, I will check the machine inspector and give your suggestion a try. Last time I opened the machine inspector the limit switches, z-probe, and X-Controller buttons were all registering green when activated.