X controller smoking

I was working on a project and my xcarve stopped halfway into finishing carving. I noticed the x controller was smoking and the power light was blinking. What should I do?

Unplug it and open it up to see what the damage is.

Ah, the magic smoke problem. Hopefully it hasn’t dissipated too much. You’ll need to use a jar to capture it and put it back into the X-Controller :grin:

Barring that, call Inventables support on the phone and explain the situation.

I think Inventables also offers a smoking cessation clinic too.

I had the same issue last night. What did you find out?