I fixed it
I changed the baud to 115200 and
yipee it worked
You are a solid rock my friend
Finaly I can start experiment with cutting
a BIG thankĀ“s
Kristian
'm frustrated
I wonder if I have forgotten any setting in the toolpath
when I have marked what is being milled
And starts,
the cutter goes up from the zero position to the workpiece
But does not go downto the pattern , but start working in the air above the workpiece
Iāve tried another thinner bit before I started,
And that was fine
Then the bits went down to the material and milled.
Sorry if I spelled something wrong here
after all IĀ“m Swede
Kristian
THX Phil
That sounds logical
Iāll check it out tomorrow
Right now I have a date with my pillow
IĀ“ll give you feedback tomorrow
Good morning Phil
It didnĀ“t worked
I took some printscreens
Please take a look and see if there is something wrong
Kristian
no i havenĀ“t start using probe yet
but I will try another thing today
IĀ“ll remember that Robert
Hi Guys
I noticed, when I reseted both the Y, X and Z in my UGCS
It seems to worked.
ThankĀ“s for all the support from you guys
I have sent you all a star to heaven.
IĀ“ll come back if the problems come back
Kristian
Hi Guys
Now Iāve got a new problem
After x-carve have cut half of ther sign
It starts to go extremely slowly.
Itās hacking
Anyone knows why
I tried to attached a small video
but it didnĀ“t work
Hmmm that is pretty interesting