Bit & Materials for Plaques

1

I’ve been asked to make a few plaques for some firefighter buddies and trying to figure out what metal material I need as well as bit recommendations for the center part of the attached image.
WATP-p2790-x

2

this might help

Amazon.com : Engraving Plates Blank Anodized Aluminum Assortment 15 Piece 3-Colors Gold, Silver, & Black : Arts, Crafts & Sewing

Amazon.com: Blank Large Black-on-Brass Engraving Plate : Home & Kitchen

1 Like
3

Thanks Ken. What bits would you recommend to engrave on these materials?

1 Like
4

I use a diamond drag 90 degrees, or v-bit at depth of.005 to start with

20220222_104511
20220222_1045111920×697 72.8 KB

2 Likes
5

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.