Can't Specify a .25" 11° bit in Easel 2-stage carving - reverts to .125"

So I thought I’d finally do a few full projects in Easel Pro to come up with my final verdict for the little survey they sent around asking if I’d subscribe to Pro.

This is curious: Set up a two stage carve. First is using a .125" FEM bit. That ran fine. Second was using a 11° .25" carving liner. But Easel immediately reverts the diameter back to .125" every time I try change the diameter to .25"

Anyone encounter this before? See attached screenshot to see where I mean.

had the same issue trying to change a 60 degree bit…kept reverting to 90