My machine all of a sudden has decided to go where the heck it wants to. I have been setting it up as always starting in the lower left corner go through the steps and hit carve but it goes clear to the far right corner instead of to the board to start carving.I’v tried switching the directions around but still goes to that corner. Any help out there?
Check your file and see if there happens to be something clear up in the corner. Run the simulation and see if there is a line going up off your project.
3 Likes
Good suggestion, Wayne. I’ve been surprised a few times when doing a select-all and it grabs tiny little things left behind when designing.